850 T-5R L5-2.3L Turbo VIN 58 B5234T5 (1995)
BB
Installing alternator cable
At the starter motor solenoid:
DO NOT REMOVE THE OLD CABLE BETWEEN THE STARTER SOLENOID AND THE ALTERNATOR.
Remove engine cooling fan with shroud according to step 1. In this bulletin.
Remove
-
Cover over the starter solenoid.
-
Nut holding the cables on the starter solenoid, (13-mm.)
-
Locate and remove from the solenoid stud, the cable terminal (eyelet) for the alternator cable (red cable, thinner of the two red).
-
Cutoff the red cable 25 mm (1.0 inch) from the terminal (eyelet) and insulate the cut off completely end with tape as per illustration.
On the alternator:
Remove;
-
Cover cap for the cable on the alternator.
-
Nut on 8+, 13 mm.
-
Cable from 8+ on the alternator.
-
Cut off the cable 25 mm (1 inch) from the B+ terminal (eyelet) and insulate it completely with tape as per illustration.
Install new alternator cable