850 T-5R L5-2.3L Turbo VIN 58 B5234T5 (1995)
Drilling hole in stub axle
-
Drill a hole in the center of the end of the stub axle. The hole should be
0/ 6 mm (15/64") and 16 mm (5/8") deep.
Warning!
When drilling, protective eyewear should be worn.
Installing sleeve and brush
-
Install sleeve and brush as far as they will go into the hole. (The edge of the sleeve should be approx. 3 mm (1/8") outside the stub axle and the outer
end of the brush should be 7 mm (9/32") outside the sleeve.)
Installing new grease cap
-
Install new grease cap.
(Use tool 999 5225-1 to distribute the force of the blow to the edge of the cap so as not to deform it.)
-
Install wheels.