850 T-5R L5-2.3L Turbo VIN 58 B5234T5 (1995)
Check that none of the pins or sockets on the connector are damaged.
- Install new control module TCM.
- Ignition ON.
- Read off any DTCs set and then clear them.
Then continue with:
Adaptation of the throttle position (TP) signal AB4.
AB4
Adaptation of the throttle position (TP) signal
The TP signal must be adapted whenever a new control module is installed. Proceed as follows:
- Block all four wheels
- Start engine.
Important! Apply parking brake and press down hard on the brake pedal with left foot during the entire procedure.
- Set gearsh itt selector to position D
Fully depress the accelerator pedal (AP) so the kickdown switch closes.