850 T-5R L5-2.3L Turbo VIN 58 B5234T5 (1995)
Place the side of the drift marked AW against the seal ring turned as shown in the picture to the right.
Carefully tap in the seal ring until the drift is up against the transmission housing.
X6
Install right drive shaft
NOTE: Make sure that the seal rings in the transmission and the boot on the drive shaft are not damaged.
Replace bearing cap.
Torque: 25 Nm (19ft.lbs)
X7
Install left drive shaft.
Ensure that the Anti-Lock Braking System (ABS) sensor pulse wheel is free from dirt.
Press the drive shaft in firmly so that it locks on to the differential gear. Ensure that the drive shaft lock ring sits in its locking groove. Check by pulling
carefully on the drive shaft CV housing.
NOTE: Make sure that the seal rings in the transmission and the boot on the drive shaft are not damaged.
X8
Reinstall:
