850 T-5R L5-2.3L Turbo VIN 58 B5234T5 (1995)
Rear Door Window Motor: Service and Repair
The procedure for replacing the power window winder motor is the same for both front and rear doors.
Removal:
-
Work with door open.
-
Remove door panel.
-
Wind window up as far as it will go.
-
Fix window with tape, run tape over door frame.
-
Undo winder motor screws.
-
Undo connector.
Installation:
-
Connect connector to winder motor, fit it in place and put screws back in (torque setting 10 Nm/7.5 ft.lbf).
-
Remove tape holding window.
-
Check that winder motor is working, wind window right down then right back up again.
-
Reinstall door panel in reverse order.
