850 Turbo L5-2.3L Turbo VIN 57 B5234FT (1996)
5. Remove drain hose (F5).
6. Undo 4 (four) heat exchanger screws (F6). The Image above shows the two left-hand screws: the right-hand pair are in the same position on the
other side.
7. Undo heat exchanger pipe flange screws (F7).
NOTE: Put a thick layer of absorbent paper under the flange first to soak up any escaping coolant.
8. Remove heater and cover (F8):
-
First, disconnect pipes from heater.
-
Then disconnect heater and cover by pulling them backwards towards the gear lever, twisting them slightly upwards at the same time. Once the
heater can move freely relative to the upper section of the climate control unit, remove it to one side.
9. Remove heater from cover.
-
Remove screws (4) from lower section of heat exchanger.