850 Turbo L5-2.3L Turbo VIN 57 B5234FT (1996)
6. Cover radiator with shield 5474 (6).
7. Disconnect pipe connections on compressor (suction pipe)(N7).
8. Disconnect snap-on connections (N8):
-
Disconnect snap-on connections from receiver/dryer. Use snap-on remover tool 5472.
-
Remove right-hand headlamp cover.
-
Remove screw from receiver/dryer bracket.
9. Remove air guide (2 x T3O torx screws)(N9).
10. Remove receiver/dryer and bracket:
-
With bracket suspended from side member, lift receiver/dryer out.
11. Remove receiver/dryer from bracket:
-
When replacing receiver/dryer, fill the new receiver/dryer with 90 cm3 of fresh oil. See: Service and Repair (General Repair instructions)
-
Switch hose to new receiver/dryer, torque setting 30 Nm (22 ft lb).
NOTE: Suction pipe position is relative to receiver/dryer.
