volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Fuel Pressure|Specifications|Page 3282 > < Fuel Pressure|Specifications|Page 3280
Page 4
background image

If the pressure is OK:
-

Check the pressure regulator.

-

Proceed to: PRESSURE REGULATOR, INCREASE IN PRESSURE section below.

If the pressure is not OK:
-

Replace the pressure regulator.

Checking the Pressure Regulator, Increase in Pressure
^

Connect pressure tester P/N 9985496 and manometer P/N 9995230 to the pressure regulator.

^

Pump up the pressure in the regulator.

^

Check that system pressure rises as much as the increased pressure in the regulator.

300 kPa (43.5 psi) + overpressure = system pressure

^

Disconnect the hose from the pressure tester. 

System pressure should return to 300 kPa (43.5 psi).

If the pressure regulator is OK:
-

Check the residual pressure. 

If the pressure regulator is not OK:
-

Replace the pressure regulator.

Checking Residual Pressure
^

Switch ignition OFF.

^

Disconnect jumper lead between relay base terminals 1 and 3.

^

Reinstall fuel pump relay.

System pressure must not fall below 200 kPa (29 psi) in less than 20 minutes.

If pressure is correct:
-

Proceed to: DISCONNECTION OF PRESSURE GAUGE section below.

If pressure is incorrect:
-

Fault may be due to leakage from injectors, connections, fuel pump non-return valve or lines. 

-

Repair as required.

Fuel Pressure|Specifications|Page 3282 > < Fuel Pressure|Specifications|Page 3280