850 Turbo L5-2.3L Turbo VIN 57 B5234FT (1996)
-
new ground screw (P/N 946544-4).
-
apply rustproofing agent (P/N 1161422-9) to screw and cable terminal.
B
Treating connector
Remove:
-
connector from terminal (lower arrow in illustration).
-
oxide from the contact surfaces by disconnecting and reconnecting the connector halves at least 10 times.
-
blow clean with compressed air.
Check:
-
that pins are intact and correctly located.
-
that cables are correctly crimped in the cable terminals by pulling cables gently.
Grease:
-
with low-temperature grease (6 grams P/N 1161427-8 or 30 grams P/N 1161417-9 or 125 grams P/N 1161236-3).
Install:
-
contacts.
C
Replacing spark plugs
If ignition conditions and/or starting difficulties persist after A and B have been carried out:
-
Check distributor and HT leads.
-
Replace spark plugs.
D
Replacing battery negative lead
Note!
Carry out the following corrective action D (below) on cars within the range of chassis numbers in the table listed above if ignition conditions and/or
starting difficulties persist despite A, B and C having been carried out: