850 Turbo L5-2.3L Turbo VIN 57 B5234FT (1996)
Extending the link arm which is located nearest the windshield wiper unit and motor shaft makes an angle of 166.1 degrees, see illustration.
-
Press down the crank link on the motor shaft serrations.
-
Remove template.
-
Apply thread sealant liquid P/N 1161053-2 on the motor shaft threads.
-
Tighten nuts to 20 Nm (14 ft. lbs). Use 26 mm fixed head wrench as counter on the crank link when the nut is tightened to the correct torque.
-
Install wiper unit according to LAE8-LAE10 in the service manual referred to above.
-
Verify function and adjust if required until unit is operating satisfactorily. See Service Bulletin 36-804 regarding positioning and adjusting wiper
arms.
WARRANTY STATEMENT: Claims may be submitted under the New Car Limited Warranty when a manufacturing defect is present using claim type:
01
Operation No.
Labor description
Time allowance
36302-2
Windshield wiper motor, replace
0.6 hr
