940 L4-2.3L SOHC VIN 88 B230F (1992)
Radiator Cooling Fan Motor: Testing and Inspection
Engine Cooling Fan & Relay
Without Engine Cooling Fan Ignition Advance System
When performing the following tests refer to SCHEMATIC DIAGRAMS/ELECTRICAL AND ELECTRONIC DIAGRAMS.
1.
Turn ignition to ON position.
2.
Connect a suitable jumper wire between thermal switch electrical connector terminals. Do not disconnect electrical connector.
3.
With jumper wire properly installed, the engine cooling fan should activate.
4.
If fan does not operate, visually check relay, relay wiring and electrical connector for open and/or short circuits, relay for correct installation,
incorrectly grounded and/or damaged electrical connector. After conducting repairs on either the wiring, relay or electrical connector, repeat step
3.
5.
If fan still does not operate, replace relay and repeat test procedure.
Engine Cooling Fan Ignition Advance System
When performing the following tests refer to SCHEMATIC DIAGRAMS/ELECTRICAL AND ELECTRONIC DIAGRAMS.
1.
Install a suitable ignition timing light onto engine as per manufacturer's instructions.
2.
Start and operate engine until normal operating temperature is reached.
3.
With engine idling, connect two jumper wires at thermal switch to each other.
4.
With the jumper wires connected, the electrical cooling fan should operate and the ignition setting should advance by 13° as indicated by the
timing light.
5.
If either the electric cooling fan does not operate or ignition timing is not advanced by 13°, replace relay assembly as required and repeat test
procedure.
