940 L4-2.3L SOHC VIN 88 B230F (1992)
If there are accessories connected to the accessory cabling, the new cable harness connectors should be connected between the existing ones.
Installing control module from kit
F9
Connecting and mounting control module in cars without SRS (Airbag) and knee bolster
-
Connect control module and cable harness connectors.
-
Apply three sections of butyl tape to the control module.
-
Install control module to dashboard side section with butyl tape.
F10
Fastening cables In cars without SRS (Airbag) and knee bolster
-
Fasten cable harness and relay to the air hose that runs above the glove compartment to the side defroster with cable ties.
