940 L4-2.3L SOHC VIN 88 B230F (1992)
Plastic pull rod: Press in the cleat (1) and remove the detent sleeve and spring.
M46: Raise the reverse detent ring slightly. Release the ring from the pull rod (2). Withdraw the pull rod downwards.
M47: Lift up the reverse detent ring and pull rod as a unit. Dismantle the parts.
5. Fit the reverse detent mechanism. Check that the rubber bushes and cables for the overdrive (M46) are in position.
M46: Insert the pull rod from the underside. Connect it to the reverse detent ring.
M47: Assemble the pull rod and reverse detent ring. Insert the pull rod from above.
NOTE: The lower clinch cleat of the pull rod must face outwards. Ensure that the pull rod is in the correct position on the inside of the lock cleat
on the reverse detent ring.
6. Fit the spring and the reverse detent. Press the cleat on the pull rod securely into the hole.
