940 L4-2320cc 2.3L DOHC VIN 89 B234F FI (1991)
Clamp press tool on camshaft.
Remove remaining bearing cap nuts and caps (1, 2,3 and 5).
Inspect bearing surfaces for signs of wear.
Remove press tool 5021 and lift out camshaft together with distributor.
Remove tappets from camshaft carrier
Magnet or suction cup may be used to facilitate tappet removal.
Inspect tappets for signs of wear.
NOTE: Store tappets upside down to prevent drainage of oil. Ensure tappets are placed in order - they must not be interchanged.
Clean/inspect camshaft carrier
Clean and inspect camshaft bearings and tappet bores for signs of wear.
