940 L4-2320cc 2.3L DOHC VIN 89 B234F FI (1991)
Tighten bearing cap nuts and center nut
Tighten to 20 Nm (15 ft.lb).
Refit distributor
Reconnect high tension lead between distributor cap and ignition coil.
Remove paper in camshaft carrier openings.
NOTE: Replace ignition lead clip beside left-hand bolt.
Seal front and rear camshaft bearing caps
Use silicone sealer.
Apply bead of sealer to angle between cap and joint face.
Install new gaskets and replace valve cover
Inspect rubber seal behind camshaft on exhaust side. Position spark plug well gasket with arrow pointing to No.1 cylinder and marking facing upwards.
Shape outer gasket to fit camshaft bearing caps. Place gasket in position and replace valve cover.
