940 L4-2320cc 2.3L DOHC VIN 89 B234F FI (1991)
NOTE: Remember to connect earth lead to distributor.
Install:
- ignition leads (in correct firing order)
- ignition lead cover plate
Fit new seals
Use assembly tool 5025.
Grease seals.
Press in seals.
NOTE: Camshafts must not be allowed to rotate when fitting seals. Face of seal should normally be flush with chamfered edge in camshaft carrier.
However, if shaft end shows signs of wear, seal may be located approx. 2 mm further in.
Replace upper section of transmission mounting plate
Adjust plate so that camshafts are centered in holes. Replace bolts between camshafts and under righthand idler.