940 L4-2320cc 2.3L DOHC VIN 89 B234F FI (1991)
Unbolt alternator and servo pump bracket
Undo bracket under intake manifold.
Tie bracket and assembly to wheel housing.
NOTE: Protect wheel housing from scratches.
Remove:
- bolts securing balance shaft housing to cylinder block.
Place container underneath joint (or place paper on front crossmember) to collect oil spillage from housing.
Remove balance shaft housing
Use extractor 5376.
Position tool over rear mounting point.
Separate housing from cylinder block carefully. Use tool (e.g. 5196) simultaneously to prise loose front mounting to assist in removing housing.
CAUTION: If housing is to be reused, it must be removed evenly from front and rear mountings.
Clean mounting points
Clean joint faces on cylinder block.
