940 L4-2320cc 2.3L DOHC VIN 89 B234F FI (1991)
Install balance shaft housing
Ensure housing is aligned evenly on front and rear mountings. Max. permissible deviation between mounting faces with reference to block is 1 mm (0.04
in).
Tighten bolts alternately in diagonal pattern. Tighten each bolt by max. 1/2 turn at a time.
Tighten bolts to 20 Nm (15 ft.lb).
Slacken and retighten to 10 Nm (7.5 ft.lb) and through a further 90°.
NOTE: Check that shaft does not seize in housing during tightening procedure.
Tighten bolted joint between housing halves
Tighten to 5 Nm (3.5 ft.lb).
Install drive pulley
Use counterhold 5362.
NOTE: Slot in pulley hub must be aligned with guide pin on shaft end. Shallower side of pulley must face inwards.
Tighten center bolt to 50 Nm (37 ft.lb). Use tool 5362 as counterhold.
Check axial clearance of balance shaft
