940 L4-2320cc 2.3L DOHC VIN 89 B234F FI (1991)
12. Transfer pressostats to new condenser. Use new seals.
Tighten pressostats to 3.5 Nm (2.6 ft lb).
13. Transfer rubber bushings on locating pins to bottom of new condenser.
NOTE: In some instances, rubber bushings may also be installed between top of condenser and radiator member.
14. Install and reconnect condenser.
NOTE: Use new O-rings. Coat O-rings with compressor oil.
Torques:
To condenser
25 Nm (18.4 ft lb)
From condenser
20 Nm (14.8 ft lb)
NOTE: After tightening: Coat complete fitting, nut and pipe, as well as inspection hole in nut, liberally with anti-rust agent (PIN 1381065-0).
15. Install air baffle between spoiler and radiator.
16. Install condenser.
NOTE: Ensure that rubber bushings (two) are seated in crossmember when installing condenser.