940 L4-2320cc 2.3L SOHC Turbo VIN 87 B230FT (1992)
1. Slacken parking brake adjuster.
^
Jack up and support rear of car.
^
Remove wheel.
^
Mark wheel position if locating stud is not fitted.
2. Remove brake pads and brake caliper.
^
Tie up caliper with steel wire to ensure that hose is not damaged.
3. Remove brake disc.
^
Remove locating pin and brake disc.
^
If disc is stuck, tap lightly with plastic mallet to loosen.
4. Ensure that all mating surfaces are clean
5. Install brake disc and locating stud.
^
Tighten stud to 8 Nm (6 ft. lbs.).
6. Install brake caliper.
^
Use new bolts.
^
Tighten to 58 Nm (43 ft. lbs.).
^
Install brake pads.
7. Refit wheels as per markings.
^
Finger-tighten nuts, then torque diagonally to 85 Nm (63 ft. lbs.).
8. Readjust parking brake.