940 L4-2320cc 2.3L SOHC Turbo VIN 87 B230FT (1992)
Place the control unit upside down on the static dissipation mat. Using a small screwdriver, open the control unit by bending the tabs up. Fully open them
with pliers. All tools must be ESD approved.
Turn the control module over so that the cover is up. Place the control module so the connector is away from you.
Carefully lift the cover making sure that it does not come in contact with the components on the circuit board.
REMOVE THE EPROM COVER
Insert a small screwdriver (ESD approved) in each slot on the cover and pry carefully.
When it is loose, lift it.
Mark the EPROM with the "scrap" sticker provided in the kit; this will prevent it from being reinstalled in error.
