940 L4-2320cc 2.3L SOHC VIN 83 B230FD (1993)
176°F (+80°C) 290 - 364 ohms
8.
If a fault occurs, measure at coolant temperature sensor to see if the sensor or the wiring is the problem.
a. If reading is the same at the sensor, replace sensor and retest.
b. If reading at sensor is correct, check wiring and ground connection.
9.
Disconnect the test equipment. Remove the #1 fuse and reconnect the ECU and all other connectors, install the kick panel and glove compartment.
Ensure that the rubber seal in the ECU connector is installed before it is connected to the unit.
10.
Reinstall the #1 fuse.
