940 L4-2320cc 2.3L SOHC VIN 83 B230FD (1993)
^ Connection pin numbers are printed on the connector side.
Checking Pin 28
6.
Turn ignition ON.
7.
Connect a voltmeter between ground and pin 28 at ECU connector.
Reading: approx. 0.7 volts
8.
Turn ignition OFF.
9.
If rading in step 7 was incorrect, check wiring and connectors. If wiring and connectors are O.K., check ignition system.
10.
Disconnect the test equipment. Remove the #1 fuse and reconnect the ECU and all other connectors, install the kick panel and glove compartment.
Ensure that the rubber seal in the ECU connector is installed before it is connected to the unit.
11.
Reinstall the #1 fuse.
