960 L6-3.0L VIN 95 B6304F (1993)
Mass Air Flow Sensor: Description and Operation
Air Mass Meter
PURPOSE
The mass air flow sensor provides the ECU with continuous information regarding intake "air mass."
OPERATION
In operation, a "hot wire" is heated to a temperature of 311°F (155°C) above ambient temperature. This temperature is maintained regardless of
outside air temperature. As air flows through the sensor, the current through the wire increases to maintain the 311° temperature.
The electronic control unit uses this current change as a signal of air mass entering the engine. The current is sensed by reading the voltage drop
across the measuring resistor in the sensor. Changes in intake air temperature are corrected by the compensating resistor.
The hot wire is mounted in an inner sleeve for protection. Each end of the mass air flow sensor also has a protective screen attached to help
prevent damage to the wire. To clean the heated wire of contamination, it is heated to 1800°F (1000°C) for approximately one to five seconds
when the engine is switched off.
The following conditions must exist before the burn-off circuit operates:
1.
Time delay of 2.5 seconds after switching off key.
2.
Coolant temperature of 140°F (60°C) or greater.
3.
Prior to switching off, the engine must have been run above 2000 rpm.
4.
No speed signal present.
COMPONENTS
^
Heated Wire (Platinum)
^
Measuring Resistor
^
Compensating Resistor
^
Micro Processor
