960 L6-3.0L VIN 95 B6304F (1993)
9. Install spring strut to the stub axle.
-
Use new screws and nuts.
-
Tighten to 65 Nm (48.0 ft. lbs.), then angle-tighten to 90°.
10. Tighten the spring strut mounting nuts.
-
Tighten nuts (D) to spring strut mounting on body work to 50 Nm (36.9 ft. lbs.).
11. Installing ABS sensor and anti-roll bar link.
-
Install the ABS sensor (A) to the stub axle
Clean the ABS sensor for installation.
Install ABS sensor screw.
Tighten to 8 Nm (5.9 ft. lbs.).
Reinstall the sensor cable on the spring strut (B).
-
Reinstall anti-roll bar link (C) on the spring strut.
Tighten to 50 Nm (36.9 ft. lbs.).
12. Remove the jack
5 Bolt Wheels Tightening Pattern
13. Install wheel.
-
Ensure that the brake disk and wheel rim mating surfaces are clean. Grease the hub center location dowel for the rim.
-
Use rust inhibitor. P/N 1 161 030-0. Install wheel studs but do not tighten.
-
Tighten crosswise to 85 Nm (42.1 ft. lbs.).
-
When using an impact wrench ensure torque socket is used.
14. Lower the car.
