960 L6-3.0L VIN 95 B6304F (1993)
- Check that gear lever is in position P.
- Connect cable at gear lever end.
- Install circlip.
Installation of right-hand side panel
- Reconnect connectors.
- Check key lock function as described in Service Bulletin 4-43-708
- Refit carpet under right-hand side panel.
- Tighten both screws at rear edge of panel.
- Lower support bracket into position between side panels and hook in position on right-hand side.
- Tighten screws.
Test operation
Adjust clearance between control rod and gear lever arm. Check shift lock override. Check overdrive switch.
Installation of tunnel cover panel and center console
