960 L6-3.0L VIN 95 B6304F (1993)
-
dial gauge and magnetic holder on stand
Radial runout must not exceed 0.05 mm. If value is greater, new nut must be installed.
Pinion radial runout is affected by nut tolerances.
Note!
200 N-m (147 ft.lbs.) must not be exceeded.
^
Recheck radial runout.
Mark highest point (i.e. point at which runout is maximum) on periphery of drive flange. Use felt pen.
Marking should be as close to pink marking on propeller shaft as permitted by hole spacing in universal joint and flange.
Propeller Shaft, Installation
Propeller shaft, installation
Inspect mating surfaces on gearbox, final drive and propeller shaft drive flanges to ensure surfaces are free of rust and dirt.
Insert propeller shaft from the front.
Note!
Fit rear universal joint to final drive flange.
Install:
-
intermediate bearing support
-
support mounting bolts
Note!
Remember to install washer between support and bearing.
-
Do not tighten bolts at this point.
