C30 T5 L5-2.5L Turbo VIN 67 B5254T7 (2008)
Applies to vehicles with tow bar wiring.
-
Disconnect all terminals from the connector.
Note! Note the location of the cables in the connector.
-
Use special tool 9512810 or 9512632.
-
Insert the tool in the connector and release the locking.
-
Pull out the cable with terminal.
-
Pull out the cable harness through the rubber grommet.
-
Remove the rubber grommet, it shall not be re-used.
Applies to vehicles with tow bar wiring.
-
Cut off the free rubber spout (1) on the rubber grommet of the PAS wiring.
-
Thread the tow bar wiring through. Lubricate the tow hitch wiring using Volvo's low temperature grease and thread the tow bar wiring (2) through.
-
Connect the terminals to the connector.
-
Secure the locking and connect to the trailer module (TRM).
-
The existing 5 pin green connector is connected to the trailer module (TRM) (1).
-
Detach the connector to the control module and connect it to the PAS wiring (2).
