volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Ultrasonic Sensor, Antitheft|Service and Repair|Page 15016 > < Ultrasonic Sensor, Antitheft|Service and Repair|Page 15014
Page 6
background image

Removing the rear door's courtesy handle:

-

Hold down the courtesy handle over the right-hand rear door. Pry loose the screw cover using a small screwdriver and remove the screws.

-

Carefully pull off the handle (some force is required to remove it).

Note! Do not damage the roof panel.

Lowering the roof panel:

-

Turn the clip in the centre of the roof panel 90° and pull off.

-

Loosen the rubber strip on the top edge of the right-hand rear door.

-

Carefully lower the roof panel.

Note! Exercise care so that the roof panel does not break further forward in its fasteners.

-

Hang up the roof panel by the rear edge if necessary.

Installing the sensor

1.

Note! Do not damage the roof panel or the rear window washer hose.

-

Take the sensor with the blue connection from the kit.

-

Loosen the ready routed, taped connector from the roof panel.

-

Plug in the connector to the sensor.

-

Remove the protective paper from the tape on the sensor.

-

Place the sensor in the four recesses in the roof panel, where the blue connector was located. Ensure the senor is straight.

Note! In order for the sensor to work correctly, it must be located within the corner markings and must not be misaligned by more than 5
degrees.

-

Hold the underside of the roof panel and push on the sensor.

Reinstall:

-

clip in the centre of the roof panel.

-

the screws in the attachment above the rear side window. Tighten with 50 Nm (37 lbf.ft.) and push on the cover.

Ultrasonic Sensor, Antitheft|Service and Repair|Page 15016 > < Ultrasonic Sensor, Antitheft|Service and Repair|Page 15014