C30 T5 L5-2.5L Turbo VIN 67 B5254T7 (2008)
Illustration A
-
Remove the bumper cover from the body by carefully prying off the ends using a weatherstrip tool. Pull off the cover under the tail lamp and from
the rear edge of the wing on each side. It is secured by four clips at the tail lamp and four in the rear edge of the rear wing. Pull the bumper cover
straight back.
Illustration B
-
Disconnect the connector for the license plate lighting, on the left-hand side. If the car has rear parking assistance, disconnect the connector on the
right-hand side.
-
Remove the pieces of tape.
Steps 20-23 apply to cars with a 4-cylinder engine
-
Mark for drilling the radiated heat shield through the left-hand hole in the lower section of the body and in the radiated heat shield. Mark the
middle of the hole by pressing through the panel using a scriber.
