C30 T5 L5-2.5L Turbo VIN 67 B5254T7 (2008)
Install the dial gauge in the bracket.
Position the tip of the dial gauge against the brake disc. Rotate the brake disc slowly.
Note the test gauge run-out. Brake disc lateral run-out must not exceed 0.040 mm.
If lateral run-out exceeds the value, replace the brake disc.
To replace the brake disc, see: Rear brake disc See: Service and Repair/Rear Brake Disc.
Finishing
Remove the test equipment.
Install the caliper holder and the brake caliper. Use new screws on the caliper holder.
Tighten, see: Tightening torque See: Specifications/Tightening Torque.
Note! Use new mounting screws.
Install the wheel. See: Wheels See: Maintenance/Wheels and Tires/Wheels/Service and Repair.