C30 T5 L5-2.5L Turbo VIN 67 B5254T7 (2008)
-
Adjust the position of the junction connector so that the measurement is 135 mm (5 5/16").
-
Tighten the hose clamp securely.
-
Reinstall the cables of the engine heater and front intake in their clamps.
Cable routing
-
Route the cable (1) to the top of the engine compartment.
-
Clamp the electrical cable with a double clamp at the lower of the two horizontal brake pipes at the top edge of the firewall.
-
Install three clips from the kit on the front edge of the panel above the windscreen wiper motor.
-
Guide the cable up to the top of the engine compartment to the position illustrated.
Illustration A
