C30 T5 L5-2.5L Turbo VIN 67 B5254T7 (2008)
-
Install the holder with the connected timer relay with the hose clamp.
Illustration B
-
Check that the same dimensions as in the image are used.
-
If the cables for the front intake and engine block heater are disconnected, reinstall them in their clamps.
-
Route the ground lead from the timer relay.
-
Drill a - 4 mm (5/32") hole on the underneath of the right-hand front member, for the ground lead to the timer relay. Drill the hole in the middle of
the underneath of the member, opposite the brake pipe connection.
-
Remove any swarf. Rust-proof the edges of the holes.
