C30 T5 L5-2.5L Turbo VIN 67 B5254T7 (2008)
Caution! When cleaning work around the flange, not in and out. No grinding tools or similar may be used. It is extremely important that there
is no thread sealant residue or other dirt. This could cause leakage.
Note! To clean the crankshaft, use cloth 9511024.
Installation
Installing the sealing ring
Caution! Only Volvo approved engine oil may be used. Grease must not be used at all. It attracts dirt and results in the build up of coke.
Lubricate the sealing ring mating surface against the cylinder block and the lips of the seal.
Thread the seal onto the beveled section of the inner section of tool 999 7174 Drift See: Tools and Equipment/999 7174 Drift with the felt side of the
seal outwards. Install the drift on the crankshaft, 2 x screws, for the flywheel. Pull in the seal using the outer section of the drift: 999 7174 Drift See:
Tools and Equipment/999 7174 Drift using the screw in the center of the tool. The seal is in position when the outer drift bottoms out against the inner
drift. Remove the tool: 999 7174 Drift See: Tools and Equipment/999 7174 Drift. Discard the old screws for the flywheel.
Installing the flywheel
