C30 T5 L5-2.5L Turbo VIN 67 B5254T7 (2008)
Installing oil pump
Use a new gasket and new O-ring around the oil pump housing.
Tighten down: 999 5747 Socket See: Tools and Equipment/999 5747 Socket sliding sleeve at the front on the crankshaft journal.
Press in the pump over the sliding sleeve.
Install new screws as guide.
Carefully tap in the oil pump with a plastic mallet.
Tighten down the oil pump crosswise with 10 Nm.
Remove: 999 5747 Socket See: Tools and Equipment/999 5747 Socket.
Install the lower belt guard.
Installing tension pulley and idler pulley
Caution! The tension pulley and idler pulley must always be replaced when replacing the timing belt.
Install:
-
a new tension pulley with the center screw.
Screw in the center screw by hand.
Ensure that the tensioner fork is centered over the cylinder block's rib.
Make sure that the Allen head hole on the eccentric is in position 10 o'clock.
-
new idler pulley. Tighten the screws.
Installing the crankshaft's timing belt pulley