C30 T5 L5-2.5L Turbo VIN 67 B5254T7 (2008)
Remove the flame sensor (1).
Installation
Installing the flame sensor
Install the flame sensor. Tighten. See Tightening torque See: Body and Frame/Specifications.
Install the cable terminals and cables in the connectors. See:
- Flame sensor in positions 1 and 2 (blue and brown).
Note! Route the cables behind the fan motor to the connector.
Carefully push the fan housing into place.
Ensure:
-
that the connector is not trapped
-
that the cable seal on the water pump is correctly positioned and that the cable runs behind the fan motor like the others.
Install the cover using 4 screws.
If necessary adjust the pipe coupling. See: Coolant pipe fuel-powered preheater, B5254T7, L.H.D See: Auxiliary Water Pump/Service and
Repair/Coolant Pipe Fuel-Powered Preheater.
Install the control module. See: Fuel Fired Booster Heater Control Unit, B5254T7, L.H.D See: Auxiliary Cabin Heater Control Module/Service and
Repair.
Finishing
Testing the engine coolant heater
Carry out a performance test of the engine coolant heater. See: Fuel-powered preheater, checking See: Testing and Inspection/Component Tests and
General Diagnostics/Fuel-Powered Preheater, Checking.
