C30 T5 L5-2.5L Turbo VIN 67 B5254T7 (2008)
Install the evaporator far enough that the cover can be installed (approximately 3-4 mm inside the opening).
Position the front edge of the cover between the evaporator and the heater unit.
Tighten the 3 screws.
Install the loose pipe section between the evaporator and the connection in the engine compartment. Start by inserting it through the lead-in seal. Then
connect the block mounting to the evaporator using 2 M5 screws. Tighten. See: Tightening torque See: Body and Frame/Specifications.
