C30 T5 L5-2.5L Turbo VIN 67 B5254T7 (2008)
Lower the vehicle.
Remove the upper connector of the charge air hose to the charge air cooler (CAC).
Disconnect the pipe/hose connector to the receiver adjacent to the power steering fluid reservoir. See the illustration.
Route the pipe/hose down to the compressor under the vehicle.
Installing the pipe/hose between the compressor and the receiver
Note! For tightening torques, see: Specifications See: Body and Frame/Specifications.
Place the pipe/hose for the compressor in position by the upper connector to the receiver.
Install:
-
the pipe coupling, 1 M8. Ensure that the O-rings are securely located between the receiver and the pipe/hose. Tighten the screw
-
the upper connector for the charge air pipe
-
the pipe coupling by the compressor, 1 M8. Make sure the O-rings are securely located. Tighten the screw.
Carry out finishing work. See: Finishing.
Finishing
Function testing together with leak tracing
Vacuum pump the air conditioning (A/C) system. See: Vacuum pumping See: Service and Repair/Vacuum Pumping.
Fill the AC-system with refrigerant according to: Refrigerant, filling See: Service and Repair/Refrigerant, Filling.
Leak trace the air conditioning (A/C) system. See: Leak detection, tracer agent See: Testing and Inspection/Component Tests and General
Diagnostics/Leak Detection, Tracer Agent or: Leak tracing, electronic leak tracer See: Testing and Inspection/Component Tests and General
Diagnostics/Leak Tracing, Electronic Leak Tracer.
Installing shield and bumper cover