C30 T5 L5-2.5L Turbo VIN 67 B5254T7 (2008)
The only function of the clock is to display the time in hours and minutes. The clock is in the upper display.
Information is transmitted from the central electronic module (CEM) (4/56) to the driver information module (DIM) (5/1) via the controller area network
(CAN).
The customer can adjust the time using a knob at the bottom of the driver information module (DIM). During adjustment, the driver information module
(DIM) transmits the new time to the central electronic module (CEM). The central electronic module (CEM) registers the change and updates its clock
accordingly.
The customer can select the way in which the time is displayed:
-
12 hour clock. The time is automatically displayed with AM or PM
-
24 hours clock.
Seat belt reminder
The seat belt reminder reminds the driver to put on the seat belt. There are two versions of the seat belt reminder:
-
European and
-
American.
The difference between the two is described below. The signals which indicate the variant (European or American) are transmitted by the central
electronic module (CEM) (4/56) via the control area network (CAN). Two small symbols light by the lamp in the roof to indicate that the seat belt is not
fastened. The driver information module (DIM) (5/1) emits an audible signal to warn the driver that the seat belt is not fastened.
European version (applies up to and incl. structure week 200650)
All the seats in the vehicle are monitored.
The light symbols will light in the Driver information module (DIM) and in the lamp module in the roof if the belt is not fastened when the ignition is
switched on. There is an audible signal from the driver information module (DIM) when the vehicle speed exceeds 10 km/h. This continues for 6 seconds
until either the seat belt is fastened or reverse gear is selected or the audible signal is switched off using the Read button on the control stalk. The audible
signal's frequency increases at speeds exceeding 25 km/h and at speeds exceeding 40 km/h the volume also increases.
For the backseat there is status monitoring that generates various text messages depending on which belts are used. These messages are turned off 30
seconds after the vehicle has reached speed above 10 km/h.
European version (applies from and incl. structure week 200651)
All the seats in the vehicle are monitored.
Front seats:
The light symbols will light in the Driver information module (DIM) and in the lamp module in the roof if the belt is not fastened when the ignition is
