volvo Workshop Repair Guides

Volvo C30 T5 Turbo Workshop Manuals & Auto Repair Guides

System Overview|Page 19089 > < System Overview|Page 19087
Page 6
background image

then transmitted on the controller area network (CAN) to the driver information module (DIM) which lights the red warning lamp and the brake warning
lamp. The driver information module (DIM) also displays a text message.

Fuel gauge

There is sensor in the fuel tank, in some cases two. These transmit signals about the actual fuel level to the central electronic module (CEM) (4/56). The
central electronic module (CEM) sends the signals on to the driver information module (DIM) (5/1). The driver information module (DIM) receives the
signals, interprets them and displays the actual fuel level in the fuel gauge.
The low fuel level warning lamp lights when the fuel level is low. The warning lamp informs the driver that the fuel level is low. The warning lamp lights
when there has been less than nine liters of fuel in the tank for 45 seconds.
The fuel gauge is not sensitive to rapid change. This is to prevent incorrect values being displayed when cornering or driving on slopes for example.

Speedometer

The speedometer displays the actual speed the car is traveling at.
Information about speed comes from the speed sensor which is connected to the brake control module (BCM) (4/16) and the transmission control
module (TCM) (4/28). The brake control module (BCM) and the transmission control module (TCM) calculate an average speed based on the signals
sent from the two front wheels by the speed sensors. The calculated speed signals are then sent to the central electronic module (CEM) (4/56) from the
brake control module (BCM) and the transmission control module (TCM) on the high speed section of the controller area network (CAN). Depending on
the quality of the signal, the central electronic module (CEM) uses the signal from the brake control module (BCM) or the transmission control module
(TCM). The central electronic module (CEM) then sends this information on to the driver information module (DIM) (5/1) which displays the speed.
Transmission control modules (TCM) are only installed in cars with automatic transmissions. In cars with manual transmissions, the speed signal is sent
to the central electronic module (CEM) only by the brake control module (BCM).

Tachometer

System Overview|Page 19089 > < System Overview|Page 19087