C30 T5 L5-2.5L Turbo VIN 67 B5254T7 (2008)
-
Route the cable from the rubber grommet to the firewall. Route it behind the cables to the electrical distribution box.
Installing the passenger compartment connector socket
-
Move aside the insulating mat to drill holes for the passenger compartment connector bracket.
-
Clean away sealant where one corner of the bracket will sit.
-
Fit the bracket from the kit on the pin of the insulating mat's clip. Use the plastic nut from the kit.
-
Align the bracket so that its edge (1) is parallel to the edge (2) in the front edge of the door opening.
-
Drill the hole (3) in the body through the bracket using a dia. 3.5 mm (9/64 inches) bit.
-
Deburr the hole edges and apply anticorrosion agent to them.
-
Secure the bracket using a plastic nut bolt from the kit.
-
Reposition the insulating mat over the bracket. Use a carpet knife to make a cut in the insulating mat so that the bracket is visible.
