C30 T5 L5-2.5L Turbo VIN 67 B5254T7 (2008)
Note! Ensure that the cable harness does not lie against any moving components or too close to heat sources.
-
Take the short cable harness from the kit.
-
Remove the taped connector from the cable harness.
-
Pull the end with the loose terminals in under the headlamp
-
Continue to pull the cable harness (1) along the right-hand side of the car, under the expansion tank down to the cowl panel.
-
Route the cable so that it is concealed and cannot be damaged or worn. Secure the cable harness using tie straps so that it does not move.
-
Unscrew the clips holding the floor carpet.
-
Push the floor carpet to one side to access the cowl panel inside.
-
Take care not to create folds in the carpet.
-
Locate the hole for the rubber grommet under the insulation panel.
-
Make a small cut in the insulation panel starting just above the hole, continue to the center of the hole and then straight down.
