C30 T5 L5-2.5L Turbo VIN 67 B5254T7 (2008)
Illustration C
-
Fasten the junction connector with the connected cables to the brace (1) (Illustration A) using the hose clamp (2) (Illustrations A and B) and the
bracket on the junction connector. Make sure that the junction connector ends up at the center of the brace. Adjust the position of the junction
connector until the measurement is 135 mm (5 5/16 inches) (Illustration C).
-
Tighten the hose clamp securely.
-
Reinstall the cables of the engine heater and front intake in their clamps.
Cable routing
-
Make a hole in the insulating mat to access the rubber grommet in the firewall.
