C30 T5 L5-2.5L Turbo VIN 67 B5254T7 (2008)
-
Use a knife to to cut away the top of the large "rubber tip" in the firewall on the lower right side of the engine compartment.
-
Take the thermal insulator and cable tie from the kit. Fit the thermal insulator on the passenger compartment connector cable. If the insulator is too
long, cut it to a suitable length (it should cover the cable between the junction connector/timer relay and firewall grommet). Pull on the thermal
insulator as far towards the junction connector as it will go.
-
Tighten the tie strap.
-
Grease the rubber grommet with low-temperature grease (part no. 1161417-9) so that the connector slides through more easily.
-
Insert the passenger compartment connector cable through the rubber grommet and into the passenger compartment. Guide all excess cable into
the passenger compartment.
-
Reinstall the engine splash guard.
-
Remount the wheel and tighten the lug bolts to 90 Nm (66 lbf.ft.).
