C30 T5 L5-2.5L Turbo VIN 67 B5254T7 (2008)
-
Fit the rubber guard from the kit over the hose clamp.
Illustration A
-
Fit the junction connector with the connected cables onto the brace (1) using the hose clamp (2) and holder on the junction connector. Make sure
that the junction connector ends up in the middle of the brace.
Illustration B
-
Adjust the position of the junction connector so that the measurement is 135 mm (5 5/16 inches).
-
Tighten the hose clamp securely.
-
Reinstall the cables of the engine heater and front intake in their clamps.
Cable routing
