C70 L5-2.4L Turbo VIN 63 B5244T7 (2003)
New cable terminal
Caution! Always use a new Volvo original cable terminal of the recommended type and quality when replacing a cable terminal.
Identify the cable terminal
First compare the cable terminal removed from the housing with the cable terminals in the repair kit p/n 981 4235 Replaced by 9512644 See: Tools and
Equipment/981 4235 Replaced by 9512644. Look inside the box lid and compare the terminal with those in the assortment available in the box.
Note! Cable area When the correct type of cable terminal is identified choose one of the right size for the cable area required. Seal sws For
cable terminals designated sws a seal must be used. See Seal sws and plug See: Replacing Cable Terminals/Seal SWS and Plug.
Stripping the cable insulation
-
Proceed to chapter Stripping the cable See: Stripping a Cable/Stripping the Cable.
If no similar cable terminal is available in the cable terminal assortment
If the cable terminal does not compare with any of those available in the assortment in the box, check in the relevant Spare Parts Catalogue.
Note! When the correct type of cable terminal is identified in the Spare Parts Catalogue, choose a cable terminal of the right size for the cable
area required and order the cable terminal.
Soldering, General
Soldering, general
Soldering is a relatively easy method to apply to cable terminals. No expensive equipment is required and the core area dimension is not a critical factor.
The disadvantages with soldering are uneven results and that impurities and dirt on the contact points make it more difficult to get a clean soldered
