C70 L5-2.4L Turbo VIN 63 B5244T7 (2003)
Press the control panel for the power window mechanism upwards by hand from the inside.
Disconnect the connectors.
New replacement part panel on the driver's side
On replacement panels there is no prepared cutout for the power mirror control. Only a stamp on the reverse of the panel.
Carry out the following:
-
The cut-out for the power mirror control must be 23.5x29 mm
-
Cut the rear of the cardboard along the perforations using a small sharp knife.
Caution! First cut through the cardboard in the panel, from the reverse through to the leather / textile surface material.
-
Remove the cut out cardboard
-
Cut through the textile / leather surface material from the reverse of the panel.
Installation
If the weatherstrip came out with the panel on removal, install the smaller molding on the upper member for the door cassette before installing the
weatherstrip.
The smaller molding must start approximately 15 cm from the rear edge of the door (the section with double metal sheet).
Hint: It is easier to install the molding if it is lubricated using soap solution.
Equipment on and in the door
Removing the front power window lift mechanism cassette
