C70 L5-2.4L Turbo VIN 63 B5244T7 (2003)
Warning! The battery must not be connected when the control module is being removed or installed.
Install:
-
3 screws (Torx 30). Tightening torque for the control module: 10 Nm .
Caution! The screws have pressed sheet metal threads and must be positioned so that the existing thread is not damaged. Take care not to
damage the ground plate during installation.
Note! Use the old screws. When using replacement screws, use a type approved for connection to ground.
Caution! It is important that the control module is securely mounted onto the bodywork if it is to operate properly.
-
the connector to the control module by following the directional arrow (1) in the illustration.
-
control module connector by folding the striker plate (2) back until it has passed the catch. This must be done before the control module is fixed in
place.
The electrical connection to ground is direct via the ground terminal which is connected by one fixing screw. It is therefore very important that the
mounting screws are in good contact with the bodywork.
Assemble other components according to, Replacing the roll-over bar cassette See: Roll Bar/Service and Repair/Removal and Replacement
Then continue with Finishing according to Replacing the roll-over bar cassette See: Roll Bar/Service and Repair/Removal and Replacement.
