C70 L5-2.4L Turbo VIN 63 B5244T7 (2003)
activating/menu for motors/rear latch) to obtain this position.
Ignition off.
5
Remove:
-
the connector
-
one Allen screw.
Note!
Note the position of the potentiometer housing in relation to the linkage.
Carefully pull the potentiometer off the shaft. Leave the potentiometer connected to the wiring until the new potentiometer is installed.
Installing the potentiometer for the convertible top
6
Caution!
It is important that the potentiometer is installed on the shaft straight. Use the screw of the potentiometer as a guide. The potentiometer is indexed
and must not be rotated or modified.
Install:
-
the potentiometer
-
one Allen screw, tighten.
Route the cable provisionally.
Connect the connector.
Set the convertible top to the position illustrated.
7
Caution!
Check that the wiring is not trapped or pinched.
Disconnect the connector.
Remove the original tie straps and the original potentiometer.
Clamp the new potentiometer cable in position.
Fasten cable with new tie straps.
Connect the connector.