C70 L5-2.4L Turbo VIN 63 B5244T7 (2003)
-
Make sure that brake discs and rim contact surfaces are clean.
-
Grease hub center rim guide with anti-rust agent 116 1038-3.
-
Install wheel.
-
Tighten bolts handtight. Then tighten them crosswise to 110 Nm (80 ft.lb). If using an air gun, use torque socket 115 8147.
NOTE: Tightening bolts crosswise to a specific torque setting is important in preventing stresses in the brake disc.
Installing Shims
Installing Shims
Special Tools: 999 2917, 999 2809
Introduction, installing shims
A kit with a new type of shim has been developed for the rear brake calipers. The kit P/N is 272272-6 (kit with 4 shims).
NOTE: Kit 272272-6 must not be installed in cars with brake caliper 3524365-8 and 3524366-6. The piston has a "step" (lowered 180 degrees) on the
mating surface with the brake pad.
Removing the rear wheels
Remove the rear wheels.
Removing the retainer spring
